Shaped Bottles assembly instructions:
Fill the bottle with gold, gems or whatever, then apply clear epoxy to the stopper placing it into the top of the bottle. Then add the bell cap with a little more epoxy. Let dry and add the jump-ring. The stopper and bell cap may be done in two steps by letting the stopper dry or in one step.
|
Austrian Crystals assembly instructions:
The crystal should be clean. Match nuggets to crystals. Larger nuggets could be sanded on back side to make a flat bonding surface. Add clear epoxy to nugget and place it carefully on crystal. Allow to dry then add finding.
|
Locket assembly instructions:
Remove screw from locket with small screwdriver. Spread the locket ring gently open. Fill front curved lens with gold. Put the back lens over the top of the gold (wide edge of the flat lens to the inside). Carefully pick up the lenses between the thumb and indexfinger. Insert lenses into ring. Be sure that they fit tightly together as you close the ring around them. Put the screw back into the ring. Do not over tighten.
|
Victorian assembly instructions:
Match nugget to Victorian. Add clear epoxy to nugget and place it carefully on Victorian. Allow to dry.
|
Pans assembly instructions:
Place clear epoxy on the pan where you would like the gold. Add gold and set in place. Allow to dry.
|
Figures assembly instructions:
Place clear epoxy on the figure where you would like the gold. Add gold and set in place. Allow to dry.
|
14k Earring Post (SP-01 & SP-02) assembly instructions:
Match nuggets, then use 14K solder to attach them to post. Epoxy should not be used. |
